Installing the stove
Take the stove off the pallet. There are three fixing points (see fig. 1) on the stove’s body, which
can only be seen before the stove is inset into the fireplace. To access these fixing points from
inside the stove (see fig. 2) remove the following parts from the stove;
•
Grate bars
•
Side bricks
•
Cam bar
•
Catch bar
•
Ashpan and riddling tool
•
Rear Brick and casting
Fig. 1
Fig. 2
Carefully move the stove into position inside the fireplace opening, being careful not to damage
the hearth or paintwork on the body of the stove. Once the stove is in position, carefully drill into
the existing fireback through the three fixing holes using a 6mm drill bit. Place the provided
screws into the fixing holes and gently tighten them until the stove feels secure.
Fill the fixing holes with fire cement to form an airtight seal.
Refit the internal components.
The tapered bottom section underneath the stove must also be airtight to stop any air flowing
under and around the back of the stove (see fig. 3)
Fig. 3
Fixing points
(Back View)
Fixing points
(Front View)
Three edges
to be sealed