Hunter Gallery Edotion, Инструкция по установке и эксплуатации

Страница: 13 / 15

12
Hunter Fan Company 41878-01 • 05/18/04
13
41878-01 • 05/18/04 Hunter Fan Company
Uninstalling the Light Fixture
1. You must remove the wiring harness and its
components from the integrated light fi xture. You
must then install the wiring harness into the empty
switch housing included with the fan.
2. Locate the reversing switch and carefully remove the
two screws holding the reversing switch to the lower
switch housing. Now, remove the reversing switch
from the housing.
3. Remove the patented breakaway connector from
the end of the fan pull chain. Carefully loosen the
bellmouth nut from the pull chain and remove the
pull chain switch from the light fi xture housing.
4. Locate and carefully remove the two capacitors.
5. In the light fi xture housing there are the following plug
connectors: one multi-wire connector and two two-wire
connectors. Unplug the two-wire connectors; one connector
will have a black with white striped wire and a white wire
coming from the multi-wire connector.
6. You have now disconnected the wiring harness and its
components and are ready to install them into the empty
switch housing. ( e light switch remains in the light assembly
housing.)
7. Insert the pull chain and fan pull chain switch through the
round opening on the side of the empty switch housing.
 read the bellmouth nut over the pull chain and hand
tighten the bellmouth nut.
8. Reattach the breakaway connector to the pull chain.
9. Insert the reversing switch into the square hole on the side
of the switch housing. Install and tighten the two screws you
removed previously from the other switch housing.
10. Carefully place the capacitors in the switch housing.
11. Continue with Step 8-6 on page 12.
Fan
Speed
Switch
Steps 1 – 6
Steps 7 – 11
Reversing
Switch
Light
Switch
Light
Assembly
Housing
Switch
Housing
Capacitors
Bellmouth Nuts
Fan
Speed
Switch