13
45003-01 • 07/02/2009 • Hunter Fan Company
8 • Assembling the Remote Control and Mounting the Cradle
8-1. To install the battery, remove the back cover of the remote.
Insert the included 12-volt alkaline battery (Type 23A, MN-21 or
equivalent) inside the remote, matching polarity on the battery
as indicated by the + and - symbols in the battery compartment.
Replace the cover.
If you are using more than one remote controlled fan in the same
area and want to control them separately, you must change the
DIP switch settings in the remote before you install the battery.
For instructions on setting the DIP switches, read the box on the
next page.
8-2.
To install the remote cradle on a switch plate,
remove the two
screws holding the switch cover plate. Do not remove the cover
plate.
Note:
If you are installing the remote cradle on a rocker light
switch, first break off the two tabs by pushing outward.
Orient the control cradle by lining up the two mounting holes
with those on the switch. Insert and tighten the screws (do not
over tighten).
8-3. To install the remote cradle on the wall,
locate a 2 x 4 wall stud
in a convenient location. Orient the remote cradle over the 2 x 4
stud. Use 1” wood screws in either the inner or outer mounting
holes.
Wall anchors and 6-32 x 1” screws may be used in situations where
mounting to a stud is not possible. Use the inner mounting holes.
CAUTION:
The remote control device complies with part 15 of the
FCC rules. Changes or modifications not expressly approved by Hunter Fan
Company could void your authority to operate this equipment.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Note:
Use with a fan that incorporates an air gap switch (normal on-off wall
switch).
WARNING:
Maximum fan load is 100 Watts; maximum lamp is 300 Watts.
Do not use any speed control with this product.
Step 8-1
Step 8-2
Step 8-2 (Rocker Light Switch)
Removed
Tabs
