44114-01 • 03/06/2012
6
Figure 4
Figure 5
Figure 2
Using Your Air Purifier
Your air purifier was thoroughly inspected and tested at
the factory prior to packaging. Visually inspect it upon
removal from its box. Remove and discard any packaging
material. Return the unit if it shows any signs of damage
or mishandling.
INITIAL SETUP:
Figure 3
Figure 1
Pre-filter
Lower Tabs
Lower Notches
Arrow
1. Take the air purifier out of the box and remove the
clear plastic protective bag and place the unit on a
firm, level surface.
2. Before turning on the air purifier, you need to confirm
that the filters are firmly in place and have not
become loose during shipping.
3. Remove the
rear grill on the back of the unit by
gently pulling the
removal tabs away from the unit
and lift the
rear grill away. Figure 1.
4. The washable
pre-filter is mounted inside the rear
grill of the unit. Confirm that it properly covers the
grill vents. Figure 2.
5. The HEPA
filter will be resting inside the unit. If
present, remove the plastic bag surrounding the
filter and place the filter back into the air purifier.
The
filter should have an arrow on the side to
indicate air flow and the direction the
filter should
be placed back into the unit. The
arrow should
point toward the front of the unit. Figure 3.
6. The
filter tab on the lower right side of the filter,
fits into the
filter notch to ensure that the filter is
installed in the correct position. Figure 4.
7. Set the
lower tabs on the bottom of the rear grill into
the
lower notches (figure 5) in the base of the unit
and rock the
rear grill up until the top tabs snap into
place. Figure 1.
8. Plug the unit into a 120V electrical outlet.
Rear Grill
Filter Tab
Filter Notch
Filter
Rear Grill
Removal Tab
Top Tab
