Hunter Douglas Vignette Tiered, Инсталляция, эксплуатация, уход

Страница: 7 / 28

INSTALLATION
5
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark the mounting surface at each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■
Mark 2" from each end of the headrail.
➤
If more than two installation brackets came with your order, space them evenly between
the two end brackets and mark their location. Mount into wood whenever possible.
➤
With shades using a battery wand, there must be a minimum of 15" between brackets
at the motor end.
■
Center the brackets on your marks, then mark each of the screw holes.
➤
A minimum 1" flat vertical surface is required to mount the brackets.
➤
The top of the installation brackets or extension brackets should be at the desired shade
height. The brackets should be level and aligned.
➤
When using extension brackets, mark two screw holes per bracket.
CAUTION:
The rear of the brackets must be flush against a flat mounting surface. Do not
mount brackets on curved molding.
IMPORTANT:
Spacer blocks are recommended for rear fabric fold clearance. Add
3
/
4
"
for standard Vignette
®
Tiered
™
or 1" for Vignette Tiered Architella
®
. (With shades using a
battery wand, an absolute minimum of
3
/
4
" added clearance is required.) For spacer block
installation, see the following page.
Headrail
End Mark
Headrail
End Mark
Window Opening
2"
Space Evenly Space Evenly
(15" Minimum for Battery Wand
at Motor End)
2"
Extension
Bracket
Installation
Bracket