Hunt Graphics IMAGE 410, Руководство пользователя

Страница: 15 / 29

- 15 -
3
H
ENCAPSULATION
n
Ensure that you have set the temperature of the
rollers according to the recommendations for the film
you are going to use.
The rollers should be stationary (Motor indicator light off).
Set your Nip to 0. Film should be loaded evenly on the
unwind shafts.
n
Step one – The table should be pivoted into its lower
position. Pull the film down from the top unwind
position. Drape it across the face of the top and
bottom main rolls. The dull (adhesive) side should be
facing you.
n
Step two – Pull the film from the bottom unwind
position up and over the top main roll. The top and
bottom films will heat and stick together.
n
Step three - While the motor is off, use a piece of
leader board to push the films through the nip. Lower
the rollers. Press the footswitch and the rollers will
grab the film and pull it through.
n
Step four - When the film reaches the chill shoe, cut
off the piece of leader board.
*
Warning! Do not cut or slice on the surface of the
chill shoe. This will affect the output of your images.
n
Step five - Press the footswitch and feed the film into
the pull rollers. Apply brake tension to the unwind
shafts to remove wrinkles. Run the laminator for about
3 feet (1M), to work out any wrinkles. If wrinkles
persist cut the film and web the laminator again.
n
Step six - Pivot the table up into its working position.
Feed your media into the table groove. Once into the
nip, apply a small amount of tension to the media.
Film Path
Media Path