■
Installation
1. Dome Base Mounting
- Open the dome cover by loosening 3 screws using special wrench
provided.
- Mount the base of camera to a sturdy surface using 4 screws (1.5
inch) and 4 premade holes on the base of the dome.
2. Power Connect & Monitor Impedance
- DC12V/300mA regulated power supply (DC12V only)
AC24V Class 2 power supply (AC24V/DC12V)
- To avoid fire or shock hazard, must use a UL listed power supply.
- Set the monitor impedance switch to 75
Ω
. Check the impedance
switch when the screen turns blurred.
3. Camera Module Adjustment
- Loosen screws for 3-axis camera bracket and adjust the direction
and angle of camera.
- Make sure to retighten the screws for camera bracket.
- Set any function you wish to activate by using the OSD buttons.
4. Dome Cover Mounting
- Replace the dome cover to the base and tighten 3 screws.
■
Cable Connections
Control via RS-485 Interface
RS-485 Control Port
485 Control Board Connection Port
485+
(+) CONNECTION TERMINAL (TRX+)
(- ) CONNECTION TERMINAL (TRX-)
485-
The camera can be controlled by using external controllers like a Remote controller.
(RS-485 Communication)
• To control using a DVR or System Controller
Connect the RS-485 cable (TRX+, TRX-) to the connection port of the 485
control board that is connected to the DVR or System Controller.
• To control the camera by constructing an additional controller, use
Pelco-D protocol.
(Go Preset 95 : Enters into OSD menu or Set key function)
Note
12
13
Super DNR High Resolution Day/Night Dome Camera
Super DNR High Resolution Day/Night Dome Camera
DOME COVER
GIMBAL A'SSY
BASE HOUSING
DECORATION RING
DC only
AC24V
DC12V
AC IN
DC IN
AC IN
DC IN
VIDEO
POWER
RS-485(Option)
