20
21
Super DNR High Resolution Day/Night Dome Camera
Super DNR High Resolution Day/Night Dome Camera
Note
• If you press the SET button in 'AUTO' mode, You can adjust brightness
by increasing or decreasing the shutter speed. (X2~X256)
• Note that the higher the zoom level, the brighter the screen, but the
more likely it is that an after-image will appear.
• Although Noise, Spots, and Whitish symptoms may occur in SENS-UP
operation when the zoom level is increased, this is normal.
●
AGC (AUTO GAIN CONTROL):
The higher the gain level, the brighter the screen - but the higher the noise.
- OFF : Deactivates the AGC function.
- LOW : Allows automatic gain control from 0 to 24dB.
- HIGH : Allows automatic gain control from 0 to 42dB.
●
SENS-UP :
When it is night or dark, the camera
automatically detects the light level and
maintains a clear picture if this mode is
activated.
- OFF : Deactivates the SENS-UP function.
- AUTO : Activates the SENS-UP function.
●
RETURN :
Select this to save the changes in the EXPOSURE menu and return
to the SETUP menu.
Note
• When the SHUTTER is set to ESC, and the camera is set to Internal
Synchronisation, the picture may become unstable if the camera
faces a bright fluorescent light. Therefore, take care when choosing
the installation position.
• ESC and MANUAL modes are only available together when the lens
is set to MANUAL.
• When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP
is disabled.
1. LENS DC
2. EXPOSURE
3. WHITE BAL ATW
4. BACKLIGHT OFF
5. DNR ON
6. DAY/NIGHT AUTO
MAIN SETUP
Use the White Balance function to adjust the screen colors.
1. Position the cursor to point to WHITE BAL on the SETUP menu screen,
select using the Up and Down buttons.
2. Select a desired mode using the Up and Down buttons.
※
Select one of the following 5 modes, as appropriate.
●
ATW : Select when the color temperature is between 1800°K and 10500°K
●
INDOOR : Select when the color temperature is between 4500°K and 8500°K
●
OUTDOOR : Select when the color temperature is between 1800°K and
10500°K. (sodium light inclusion)
●
AWC SET : To obtain the optimum state under the current luminance levels,
direct the camera to point toward a sheet of white paper and press
the SET button. If the environment changes, including the light
source, the white balance will require re-adjustment.
●
MANUAL : Select to "fine-tune" the White Balance manually. Set White
Balance first using the ATW or AWC mode. Afterwards switch
to MANUAL mode, fine-tune the White Balance and then press
the SET button.
White Balance (White Bal.)
■
How to Use the Camera
