Humminbird MEGA 360 UNIVERSAL, Руководство по установке

Страница: 22 / 38

16 Cable Installation
NOTE: Humminbird is not responsible for over-voltage or over-current failures.
The MEGA 360 Imaging transducer must have adequate protection through the
proper selection and installation of a 1 Amp fuse.
5a. Main Switch/Fuse Panel: If a fuse terminal
is available, use crimp-on type electrical
connectors (not included) that match the
terminal on the fuse panel. Attach the black
wire to ground (–), and the red wire to positive
(+) 12 VDC power, and the drain/shield wire
to the boat’s chassis ground terminal. Install
a 1 Amp fuse (not included) for protection of
the unit.
OR
5b. Battery Switch: Install the battery switch (not included) using the instructions
provided with it. You will also need to obtain and install an inline fuse holder
and a 1 Amp fuse (not included) for the protection of the unit. Attach the
black wire to ground (-), the red wire to positive (+) 12 VDC power, and the
drain/shield wire to the boat’s chassis ground terminal.
WARNING! If you are unable to obtain a battery switch and are forced to
connect the power cable directly to the battery, be aware that this will drain the
battery. Humminbird does not recommend connecting to a battery without the
appropriate fuse and a switch.
6. Secure the cables with cable ties along the route as needed for a clean
assembly.
Connecting to the Fuse Panel