Hummer 2008 H3, Пособие по эксплуатации

Страница: 5 / 20

5
2. Press and release the reset stem
until OIL LIFE is displayed.
3. Once the alternating OIL LIFE and
RESET messages appear, press and
hold the reset stem until several
beeps sound.
4. Turn the key to Off.
Program the Automatic Door Locks
To program the door locks to operate in
one of three modes:
1. With the engine off, turn the key to
Lock. Do not remove the key.
2. Press and hold the power door lock
button for approximately three
seconds until the DIC displays the
current door lock mode.
3. To view each next available mode,
press, hold for approximately two
seconds, and then release the
reset stem.
4. Once the preferred mode is
displayed, briefly press the reset stem
to set your choice. The DIC display
will then clear.
Program the Remote Keyless Entry
Feedback
To program the Remote Keyless Entry
(RKE) feedback to one of four modes:
1. With the engine off, turn the key to
Lock. Do not remove the key.
2. Press and hold both the Lock and
Unlock buttons on the RKE
Note: The Oil Life System must be
reset after each oil change to help
ensure the proper maintenance of your
vehicle. The Oil Life System does not
replace the need to follow the
maintenance schedule in the Owner
Manual. For service information, see
Section 5 of your Owner Manual.
transmitter until the DIC displays the
current RKE feedback mode.
3. To view each next available mode,
press, hold for approximately two
seconds, and then release the
reset stem.
4. Once the preferred mode is
displayed, briefly press the reset stem
to set your choice. The DIC display
will then clear.
Selecting a Language
To select the DIC language:
1. With the engine off, turn the key
to On, but do not start the engine.
2. Close all doors.
3. Briefly press and release the reset
stem until the current language
is displayed.
4. Press and hold the reset stem until
the next language appears.
5. Repeat Step 4 until the desired
language is displayed. The language
displayed will be set.
6. Briefly press and release the reset
stem to exit the language selection.
Warnings and Messages
Warnings and messages are displayed
on the DIC to notify the driver that the
status of the vehicle has changed and
that some action may be needed by
the driver.
Each message must be acknowledged.
To acknowledge and clear a message
from the DIC, press and release the
reset stem.
If your Check Engine light, or any other
warning message appears, you can
push the blue OnStar button and speak
to a live advisor. OnStar Advisors can
access certain diagnostic information