English 9
Accessory: doorbell cable.
Congratulations on purchasing your
RF doorbell transmitter direct
. We
hope it will give you many years of
reassuring operation.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system’s features
to you.
Standard components
Please check if all following compo-
nents are included:
-
lisa RF doorbell transmitter direct
- 2 x doorbell cable, length 1 m,
- 9 V battery.
- Operating instructions
- Warranty card
If any parts are missing, please
immediately contact your dealer or
the manufacturer directly.
Operating principle
A signalling system consists of at
least one transmitter and one recei-
ver. The
RF doorbell transmitter direct
picks up the ringing signals from your
doorbell through an electrical
connection. It converts these signals
into radio pulses (868.35 MHz) and
transmits them to the receiver without
the need for wires.
Special features
When a signal is detected, it is trans-
mitted for a total of 22 se conds. This
increases both the reliability and the
range of the system.
Setting up the system –
1. Inserting the battery
There is a battery compartment on
the back of the
RF doorbell transmit-
ter direct
. Open it by sliding the
cover of the battery compartment to
the right of the receiver using your
thumb. Connect a 9 V block battery
to the connector plug, insert the bat-
tery into the battery compartment
and close the device. When the bat-
tery is connected, the receiving sig-
nals may be triggered once.
Funk_TuerklGal_2015_06:BA_Funk_TuerklGal_2015-06 26.06.2015 11:07 Seite 9