I N I T I A L U PS TA R T
24
SuperSaw 350E
En011306c_ss350.FM
Adjusting saw bar feed out pressure
1.
Lower the grapple saw to the ground and shut off the
engine.
2.
Remove the saw motor cover.
3.
Connect a suitable pressure gauge to the pressure test
point (1) using the pressure gauge hose, P/N 0724011.
Note!
Place the pressure gauge so that the pressure easily
can be checked from the operator’s cabin when the saw
function is activated.
Important!
Never adjust any hydraulic pressures without using a
pressure gauge.
4.
Start the engine and read the feed out presure when the
saw bar is completely fed out.
Note!
Do not activate the saw function more than 5
seconds at a time.
5.
Adjust the feed out pressure on the pressure regulating
valve (2).
•
Increase the pressure by tightening the set screw.
•
Decrease the pressure by loosening the set screw.
For a proper pressure range, refer to Technical Data.
6.
Remove the pressure gauge and assemble the saw motor
cover.
ill. 7
Adjusting saw bar feed out pressure
1
Pressure test point
2
Pressure regulating valve
1
2
