Hughes Jupiter, Руководство по указанию

Страница: 31 / 47

Chapter 3 • Pointing the antenna by using the DAPT3
1039429-0001 Revision D
31
10. This screen will display while the values of the measured calibration loss is
validated.
Important : This value cannot be higher than 18.
11. If the measurement is valid, the next step will be step 12. If the cable loss
value is too high, this screen will be displayed. Review the cable requirements
specification to ensure the cable you are using is the correct length.
12. When the measure calibration loss is valid, the screen will display
CableCal
Done
.
13.
Logging VoltMeas
will display momentarily while the voltage is recorded.
14. After a few seconds, the
Logging Done
message appears.
15. Press the Advance (3) button.
When the satellite modem receives the voltage response message, it
advances to the p
ointing state, during which the antenna can be coarse
and fine-pointed.
Upon entering the pointing state, the DAPT3 display reads:
The highest recorded SQF value is on the left and the current SQF reading is
on the right.