Hughes Jupiter, Руководство по указанию

Страница: 10 / 47

10
Chapter 1 • Introduction
1039429-0001 Revision D
Figure 2: DAPT3 antenna pointing tool
The three buttons on the DAPT2 and DAPT3 can serve different purposes during
different phases of the pointing process. In most cases, however, they function as
follows:

Back (button 1) – Used to return to a previous state

Toggle (button 2) – Used to change audio level and contrast

Advance (button 3) – Used to begin a process, proceed to the next state, or
respond Yes to a prompt on the DAPT2 or DAPT3 display
Entering installation parameters with a smart device
After completing physical installation of the satellite modem, connect your smart
device to the satellite modem via a wireless router by using the OASIS app. The
latitude and longitude of the antenna site, and the satellite name, will populate
automatically as you proceed through OASIS’ step-by-step installation process.
When you reach the Pointing workflow in the app, you will submit the
aforementioned parameters and put the satellite modem into pointing mode. See
the
OASIS User Guide (1040630-0001).
Azimuth measurements are calibrated relative to true north, not magnetic
north.
Pointing
After acquiring the installation parameters with OASIS, you can begin the process of
pointing the antenna at the satellite. Using the proper azimuth, elevation, and tilt
coordinates obtained from OASIS, you will point the antenna in the general
direction of the satellite to obtain initial acquisition of the satellite signal. See the
OASIS User Guide (1040630-0001)