Hughes HT2000W, Руководство по установке, Страница: 24 / 80

3. If you are running firewall software on the laptop computer, disable it until
you complete installation of the modem. The LAN LED on the front of the
modem should now be on.
Overview of entering installation parameters
Successful installation of the satellite modem depends on your tasks, network and
installation software, and interaction between the satellite modem and the
Network Operations Center (NOC). After powering up the modem, enter the
required parameters and then complete the antenna pointing.
The following apply to the screen illustrations in this guide:
•
The screen illustrations are examples. Values shown in these illustrations may
not apply to the satellite modem you are installing. Do not use values shown
to install or configure the modem unless the instructions say to do so.
•
On some screens and in some messages you may see the word modem or the
abbreviation VSAT. Both refer to the HT1100 satellite modem.
• Screen and page are both used to refer to the information displayed on your
computer monitor.
1. Open a browser on your laptop. The
Your system is not quite ready
screen
appears as shown in Figure 10. This is the first screen of the commissioning
process.
Figure 10: System not ready screen
2. The System Control Center home page appears as shown in Figure 11.
24
Chapter 3 • Installing the satellite modem
1039649-0001 Revision C