Hughes HT2000W, Руководство по установке, Страница: 15 / 80

protector). Do not remove the DC power cord from the modem's rear panel. Doing
so could result in an electrical shock or damage the modem.
When you re-apply power to the modem, plug the AC power cord into the power
source.
Table 1: Power supply specifications
Power supply type Description Electrical requirements
AC/DC, 46 W
P/N 1502015 HT1100 satellite modem
with 1 W radio only
Input line voltage: 100 - 130 V,
1.5 A maximum
Input line frequency: 60 Hz AC
Rated power consumption: 46 W
Computer and networking requirements
This section lists the requirements for the computer or other device, network, and
browser to be used with the satellite modem.
Computer requirements
The HT1100 satellite modem can be used with any device that supports Internet
Protocol (IP) and has a 10/100 BaseT Ethernet LAN port. Typically, the modem is
connected to a customer's computer. However, the HT1100 is self-hosted; it does
not require a computer for any of its functions.
Requirements for the computer to be used with the satellite modem are the same
for the laptop computer you use to install the modem. The computer should meet
the minimum requirements specified by the computer operating system
manufacturer and the following networking and browser requirements. Make sure
your laptop is configured to support DHCP.
Note: The satellite modem can be used with a Mac computer that meets these
requirements, but Mac computers are not supported as a tool for installing the
satellite modem.
Networking and Internet browser requirements
•
Ethernet port
•
Ethernet Network interface card (NIC) installed on at least one computer,
10/100 BaseT
•
Ethernet cable (provided)
•
A web browser such as Internet Explorer with proxy settings disabled
Connecting a network - If the customer wants to connect a network to the satellite
modem, this requires an Ethernet hub or other such device. The customer must
supply and configure the hub and cables. Required IP address information is
obtained during commissioning.
Chapter 2 • Preparing for installation
1039649-0001 Revision C
15