Hughes HN9000, Руководство по установке

Страница: 81 / 126

• Software Features – This section lists the optional features and provides information on whether they are currently
active. These features are enabled or disabled according to the customer’s service offering. The customer cannot use
the satellite modem to change these features.
State codes
A state code is a number that indicates the operational state of the satellite modem. Some state codes indicate an error
condition. State codes are identified as
State code followed by a number from 1 – 35. They are displayed with an
explanation in words, as shown in the following examples.
State codes appear on installation screens, on screens displayed during a hard reboot (when power is removed and then
restored), and on System Control Center pages.
Figure 46: Examples of state codes
Table 10: State codes on page 67 lists and explains all HN9000 state codes.
In the state code table, modem refers to the satellite modem .
Table 10: State codes
Corrective action Explanation State name State code
Installation – Boot phase
Transient – No action is necessary. Satellite modem is starting up in boot
phase. Starting Up in Boot 1
Transient – No action is necessary. Modem has not been installed, and
installation parameters have not been
submitted. Waiting for Installation
Parameters 2
67
Chapter 8 HN9000 Satellite Modem Installation Guide
1037576-0001 Rev. A