1035930-0001 Revision 2
6-6
Installing the feed support, RA6-TG Radio Assembly Models Feed System
1.
Place the feed support (length: 37.6 inches) at the bottom of the reflector and align the
mounting hole in the feed support with the center hole in the bottom of the reflector. See
Figure 11.
2.
Insert a ¼-20 x 1.00-inch hex bolt and flat washer through the hole in the feed support and
the center hole in the bottom of the reflector.
3.
Secure with a flat washer, lock washer and hex nut on the back of the reflector.
4.
Attach one end of each of the (2) feed rods (length: 35.4 inches) to the mounting hole in the
side of the reflector using a ¼-20 x 1.00-inch hex bolt and flat washer. See Figure 12.
5.
Secure with a flat washer, lock washer and hex nut on the inside rim of the reflector.
6.
Align the opposite end of each feed rod with the mounting hole in the feed support and
connect with a ¼-20 x 3.00-inch hex bolt and flat washer.
7.
Secure with a flat washer, lock washer and hex nut on the bolt.
8.
Securely tighten these four bolts at this time.
Reflector
Inside View
Back View
¼-20 x 1.00-inch
hex bolt with
hardware
Feed Rods
¼-20 x 1.00-inch
hex bolt with
hardware on both
sides
¼-20 x 3.00-inch
hex bolt with
hardware
FIGURE 11
FIGURE 12