1035930-0001 Revision 2
6-3
4.
Secure with a flat washer, lock washer, and hex nut on each of the four carriage bolts.
5.
Tighten securely.
Installing the feed support, RA6-074 Radio Assembly Models Feed System
1.
Place the feed support (length: 34.7 inches) at the bottom of the reflector and align the
mounting hole in the feed support with the center hole in the bottom of the reflector. See
Figure 4.
2.
Insert a ¼-20 x 1.00-inch hex bolt and flat washer through the hole in the feed support and
the center hole in the bottom of the reflector.
3.
Secure with a flat washer, lock washer and hex nut on the back of the reflector. See Figure 5.
4.
Attach one end of each of the (2) feed rods (length: 29.5 inches) to the mounting hole in the
side of the reflector using a ¼-20 x 1.00-inch hex bolt and flat washer. See Figure 6.
5.
Secure with a flat washer, lock washer and hex nut on the inside rim of the reflector.
6.
Align the opposite end of each feed rod with the mounting hole in the feed support and
connect with a ¼-20 x 3.00-inch hex bolt and flat washer.
7.
Secure with a flat washer, lock washer and hex nut on the bolt.
8.
Securely tighten these four bolts at this time.
Reflector
5/16-18 x 2.00 –inch
Carriage Bolt
5/16-18 x 3.00-inch
Carriage Bolt
Reflector
Support
Front View
Back View
¼ -20 x 1” hex
bolt and washer
FIGURE 3
FIGURE 4
FIGURE 5