11
OPERATING INSTRUCTIONS
Control Board Functions (continued)
Auger Trim:
This is used to change the feed rate on the minimum heat level for various
quality of pellet fuel. This will help to keep the flames from extinguishing on the
minimum heat level setting. It is also used to lower heat output on the minimum heat
level setting.
Push and release the Auger Trim button until the heat level 1 and 5 lights appear. This
will slightly increase the feed rate on the minimum heat level setting to keep the burn pot
flames from going out.
Push and release the button until the heat level 1 and 4 lights appear, this will reduce the
pellet feed rate on the minimum heat level setting. Use this setting to reduce the heat
level output on low.
Push and release the button until just the heat level 1 setting light is on, this is the factory
setting and works for most types of fuel.
Figure 3
Control Panel
Open Door
If the door is opened, while the unit is operating, it
must be closed within 30 seconds or the unit will go
into vacuum error mode. If this happens, close the
door, turn the control panel switch to "OFF" then
back to the setting it was previously at.
Refueling
For maximum performance we recommend that you
do not let the hopper drop below 1/4 full. KEEP
LID CLOSED AT ALL TIMES EXCEPT WHEN
REFILLING. DO NOT OVERFILL HOPPER.
Safety Features
1.
Your unit is equipped with a "high
temperature limit" thermo snap disc. This
snap disc serves to shutdown the auger in
the case of an over temperature situation
(such as convection fan failure). This disc
has a manual reset button that will have to
be reactivated once the unit has cooled
down.
2.
If the combustion fan malfunctions a
vacuum switch will automatically shut down
the auger (see also Open Door section
above).
If either of these situations occur contact your dealer as a service call may be
required.
