8
/
26
༄
Dip-Switch 2(Set Control protocol)
ON: RS-485 &PELCO-D (ON=RS485&Pelco-D)
OFF: RS-232C&VISCA (OFF=RS232C &VISCA )
༅
Dip-Switch 3 (Set as Upgrading)
Set dip switch 3 as ON, then you can do upgrading of the camera, Must
Set OFF as usual working.
༆
Dip-Switch 4& 5 (Set address code)
When you used RS232C &VISCA to control multi-cameras, suggest to
set address code as
OFF;
When you used RS-485 &PELCO-D to control multi-cameras, suggest to
refer to below Camera address code setting table;
༇
Switch 6 (Set IR signal output switch)
When set as ON, it will receive the signal from remote control and
VISCA IN to control this device, if set it to OFF means close signal
output.
Camera address code setting
Dip-switch
4
Dip-switch
5
1
OFF
OFF
1
OFF
ON
2
ON
OFF
3
ON
ON
Cable Connection info
VISCA RS-232C IN Reference
