4.3.2 Configuration Menu
Here the default values for some parameters can be changed. These values are read when the
software starts.
[1]
POWER SUPPLY
Selecting the operating voltage of the amplifier. The operating voltages can also be set
unbalanced by remote commands.
[2]
50 OHM INPUT
Selection of the state of the 50Ω input.
[3]
100 KOHM INPUT
Selection of the state of the 100 kΩ input.
[4]
INTERLOCK
Setting the interlock mode.
LATCHING: After an interlock, the interlock state must be reset by a remote command
before the amplifier can be switched through again.
LIVE: The amplifier can be switched through again immediately after the interlock state has
ended.
OFF: Interlock deactivated (default)
[5]
SAVE VALUES
The configuration data is stored as initial values in the amplifier.
[6]
LEAVE CONFIGURATION
Exit the configuration menu and return to the control menu.
A1230-02
A1230-MultiChannel-Control Software
Page 17
