8
©2018 Hubbell Incorporated | Chance
®
Capstan Hoist Operating Instructions
Capstan Rope Hook Information
Do not replace the supplied bolt with any other fastener. Using other fasteners will allow un-
authorized removal of the hook and may result in damage to equipment, injury, or death.
!
WARNING
This hook must always be properly installed on the hoist prior to any use. Failure to read and
follow these instructions may result in injury or death. Do not remove or modify the rope hook.
!
WARNING
For CHANCE
®
Capstan Hoists that come factory equipped with a rope hook, please read these
instructions and warnings, then retain these instructions for future reference. If you have purchased
a rope hook to retrofit or repair an existing CHANCE
®
Capstan Hoist, please read and follow these
installation instructions and warnings.
Installation:
Position the rope hook as shown in the illustration above. NOTE: It is recommended that the rope
hook be on the same side as the operator and not the same side as the load when the hoist is in use.
Install the supplied tamper-resistant bolt and tighten to 20 - 25 ft. lb.
Use:
Wrap the rope around the capstan drum per the instructions on page 14. Pass the rope between the
end of the hook and drum to add wraps of rope. The "fall line" should be positioned as near the hook
as practical. Ensure the "fall line" is pulled nearly 90°, or perpendicular, to the drum.
Position the fall line so that it will not pull over the end of the drum. If the rope comes off the end
of the drum and the hook catches it, stop the hoist, secure the load, and correct the rope position
on the drum.
Do not try to lower the load until the rope has been correctly repositioned on the drum. Injury or
death could result.
!
WARNING
