OUTER SHELL AND INSULATION
The tank is encapsulated in 1-inch thick fiberglass insulation. The tank and insulation is
protected by a painted steel protective jacket.
TEMPERING VALVE (Optional)
An optional tempering valve may be supplied to increase the amount of available hot water.
The ½” NPT valve is adjustable from 100° - 130° F and is typically used when supplying hot
water to multiple lavatories from a single CE110.
WALL BRACKET (Optional)
An optional wall bracket is available for easy mounting
of the heater.
SECTION II
– INSTALLATION GUIDELINES
WARNING / CAUTION
DO NOT TURN ON THE ELECTRIC POWER SUPPLY to this equipment until heater is
completely filled with water and all air has been released.
If the heater is NOT filled with
water when the power is turned on, the heating elements will burn out.
For protection against excessive pressures and temperatures, local codes require the
installation of a temperature-and-pressure (T&P) relief valve certified by a nationally
recognized laboratory that maintains periodic inspection of production of listed equipment of
materials, as meeting the requirements for Relief Valves and Automatic Gas Shutoff for Hot
Water Supply Systems. ANSI Z21.22-1971. A relief valve is designed to discharge
excessively hot water. THE CUSTOMER IS RESPONSIBLE TO PROTECT PROPERTY
AND PERSONNEL FROM HARM WHEN THE VALVE FUNCTIONS.
All water heaters have a risk of leakage at some unpredictable time. IT IS THE
CUSTOMER'S RESPONSIBILITY TO PROVIDE A CATCH PAN OR OTHER
ADEQUATE MEANS, SO THAT THE RESULTANT FLOW OF WATER WILL NOT
DAMAGE FURNISHINGS OR PROPERTY.
The warranty provided assures replacement within its terms, but specifically does not
warrant against consequential damage caused by failure to follow these instructions.
UNPACKING AND INSPECTING THE HEATER
1.
Remove the model CE110 from the shipping carton and visually inspect for any sign
of damage. A damaged unit should not be installed, but returned to the factory for
replacement.
WATER HEATER PLACEMENT
•
Locate the heater in a clean, dry location nearest to the point of most frequent hot
water use.
•
Secure the water heater. Optional wall mounting brackets may be utilized, if supplied.
•
The water heater should be protected from freezing and waterlines insulated to reduce
energy and water waste.
•
Leave sufficient room to service the heater.
•
Do not install in an area where flammable liquids or combustible vapors are present.
7