Hubbel RFL PLC Hybrid Pro, Руководство пользователя

Страница: 6 / 44

RF-MCHYBRIDPRO-01
Hubbell Power Systems, Inc. – RFL™ Products
June 2019 6 973.334.3100
1 Safety Instructions
1.1 Warnings and Safety Summary
The equipment described in this manual contains high voltage.
Exercise due care during operation and servicing. Read the safety
summary below.
!
1.1.1 Safety Summary
The following safety precautions must always be observed during operation, service, and repair of this
equipment. Failure to comply with these precautions, or with specific warnings elsewhere in this
manual, violates safety standards of design, manufacture, and intended use of this product. HPS/RFL
assumes no liability for failure to comply with these requirements.
Ground the Chassis
The chassis must be grounded to reduce shock hazard and allow the equipment to perform properly.
The Chassis is provided with a rear-panel protective earth terminal, which must be connected to a
proper electrical ground by suitable cabling. The location of the protective earth terminal on the
RFL™ PLC Hybrid Pro system is shown below. Refer to the wiring diagram supplied with the unit for
additional information on chassis and/or cabinet grounding.
Ground wire: 12-14 gauge
Attach the ground
wire to the nearest
panel grounding bar.
Figure 1 – Grounding
A protective earth stud at the right rear of the RFL™ PLC Hybrid Pro system chassis is the main
ground for the RFL™ PLC Hybrid Pro system.