MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING
CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM
42397
ASSEMBLY & INSTALLATION INSTRUCTIONS
Centre Outdoor Sconces 302610 & 302612
B401
1.
Carefully unpack the fixture (A) from the carton.
2.
Remove mounting bracket (E) from fixture and set aside.
3.
Remove lower set of thumb screws (C) and rubber washers
(D). Loosen top set of thumb screws and rubber washers but
do not remove completely.
4.
Slide front tube (B) upward and detach from fixture (A). Set
aside front tube assembly for later use (Figure 1).
See Figures 2 & 3 on next page for following instructions
5.
Using two machine screws (not provided) attach mounting
bracket (E) to the electrical box.
Note:
A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
6.
Using the green ground screw (F) and the cupped washer (G)
in kit bag, secure a pigtail lead to the mounting bracket (E).
7.
Hold the fixture (A) close to the mounting bracket (E) and using
suitable wire connectors (not provided), connect fixture wires
to supply wire (white to white and black to black). Connect all
ground wires (bare copper or green to bare copper or green).
8. Apply a generous bead of a suitable caulking material (not
provided) to caulking lip (H) on the fixture (A). Caulk should be
applied around the entire perimeter of the backplate (Figure 3).
9.
Carefully tuck all wires behind fixture (A) and inside the
mounting bracket (E). Place fixture firmly onto bracket and
fasten with two #8 screws (I) and rubber washers (D) on top.
Be sure Triangle plate is pointing upwards as seen in
Figure 2.
Note:
Be sure no wires are pinched between wall and fixture.
10.
Install the two remaining #8 screws (I) in bottom of fixture (A).
To Attach to Wall
(Figures 1 - 3)
CAUTION:
FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE.
We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution:
Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRES ARE EXPOSED.
D
C
B
A
E
(Figure 1)
3 OF 6
