9
the control of the computer as follows:
Self-inspection →boosting →constant amplitude output →shutdown The
specific process is as follows:
1)
Self inspection process
The controller automatically enters the load detection. If no load is detected, the prompt message
"load not connected" in the status bar of Figure 6 indicates that the booster or capacitive test
sample is not connected.
Figure 6 the controller indicates that the load is not connected
2)
Boosting process
After the self-test is successful, the instrument will automatically enter the boosting state, as
shown in Figure 7, and the prompt message in the status bar is "boosting".
At the same time,
the timing began.
Figure 7 the controller indicates that the voltage is boosting
