NOTE
l
In the label content,
Small Cell
identifies a Huawei micro base station.
l
For a single base station, only labels with Small Cell or Small Cell0 are used.
l
For two base stations at the same site: If UMTS and LTE base stations are located at the same site,
you are advised to label the UMTS base station as Small Cell0 and the LTE base station as Small
Cell1. If two base stations work in the same mode, label the one directly connected to external
devices as Small Cell0 and the cascaded one as Small Cell1.
Label Structure
Figure 1-62
shows the structure of a Small Cell engineering label.
Figure 1-62
Label structure
1.11.6 Attaching a Sign Plate Label
This section describes the procedures and precautions for attaching a sign plate label.
Context
l
This section applies to Huawei sign plate labels. If other engineering labels in
accordance with local standards are used on site, follow the local standards for attaching
sign plate labels.
l
A sign plate label is usually used for a power cable, ground label, signal cable, and
antenna. This section uses
1.11.5 Small Cell Engineering Label
as an example.
Procedure
Step 1
Lead the cable ties through the holes of a label, and then bind the label to the cable, as shown
in
Figure 1-63
. Ensure that the cable ties are led through the holes of the label in the same
direction.
Figure 1-63
Binding the label
RRU3931E
Installation Guide
1 RRU3931E Installation Guide
Issue Draft A (2016-03-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
57