
Silkscreen
Indicator
Description
UID indicator
The UID indicator helps identify and
locate a device.
● Off: The device is not being located.
● Blinking or steady blue: The device
is being located.
NOTE
You can control the UID indicator status by
pressing the UID button or using the iBMC.
-
PSU indicator
● Off: No power is supplied.
● Blinking green at 1 Hz:
– The input is normal, and the
server is standby.
– The input is overvoltage or
undervoltage.
– The PSU is in deep hibernation
mode.
● Blinking green at 4 Hz: The
firmware is being upgraded online.
● Steady green: The power input and
output are normal.
● Steady orange: The input is normal
but there is no output.
NOTE
The possible causes of no power output
are as follows:
● Power supply overtemperature
protection
● Power output overcurrent or short-
circuit
● Output overvoltage
● Short-circuit protection
● Device failure (excluding failure of
all devices)
Table 5-4 FlexIO card power indicator and status indicator
FlexIO Card
Power Indicator
(Green)
FlexIO Card
Status Indicator
(Yellow)
Description
Off
Off
The FlexIO card is not detected.
Steady on
Off
The FlexIO card is detected and
operating properly.
Steady on
Blinking at 2 Hz
The FlexIO card is being hot-swapped.
Huawei FusionServer Pro 2488H V6 Server
Technical White Paper
5 Hardware Description
Issue 03 (2021-02-01)
Copyright © Huawei Technologies Co., Ltd.
20