DBS3900 LampSite
Installation Guide
7 Installing a pRRU3901
Issue 08 (2016-05-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
95
Cable
One End
The Other End
Connector
Connected
to ...
Connector
Connected to ...
Ethernet
Cable
RJ45 connector
CPRI_E0~CP
RI_E7 port on
RHUB
RJ45 connector
CPRI_E0~CPRI_
E1 port on pRRU
RJ45 connector
Transmission
port on Access
Control(AC)
RJ45 connector
GE port on
pRRU3901
CPRI_E1 port
on
pRRU3911/
p
WIFI
(Optional)
RF Jumper
SMA straight
male
connector/Type
N male
connector
External
antenna
TX/RX RF
port on pRRU
Based on the
port model of
the antenna
system.
Antenna system
When the RHUB and the pRRU3901 connected using the Ethernet cable. If the Extender is used,
In the indoor scenario, the Ethernet cable is divided into two parts, one between the RHUB and the
Extender and the other between the Extender and the pRRU3901.
In the outdoor scenario, the Ethernet cable is divided into two parts, one among RHUB-PoE surge
protector 2- PoE surge protector 3-Extender and the other among the Extender- PoE surge protector
4- PoE surge protector 1-pRRU3901.
7.5.3 Cable Connections (Indoor)
This section describes the cable connections for a single pRRU3901 and multiple pRRU3901s
in UMTS, LTE FDD, UMTS+LTE FDD, LTE FDD+LTE FDD mode.
Before installing the pRRU3901 cables, you must be aware of the following information:
The pRRU3901 can obtain power supply through the power over Ethernet (PoE).
For external antennas corresponding to RF daughter board 1, the TX port and RX port
are ANT0 and ANT1, respectively. For external antennas corresponding to RF daughter
board 2, the TX port and RX port are ANT2 and ANT3, respectively. For external
antennas corresponding to RF daughter board 3, the TX port and RX port are ANT4 and
ANT5, respectively.
The external antenna system is optional, and the pRRU3901 jumpers are not delivered.
By default, the pRRU3901s are configured with built-in antennas. If the external antenna
system is connected, the antenna system automatically switches to the external one. One
end of the pRRU3901 RF jumper is the SMA male connector, which is connected to the
external antenna TX/RX RF port on the pRRU3901. The other end of the pRRU3901 RF
jumper is the type N male connector, which is connected to the antenna system. For the
standard of the pRRU3901 RF jumper, see (Optional) RF Jumper of the
DBS3900
LampSite Hardware Description
.