14
Assembly Instructions
1. Identify all components and hardware.
2. Remove inner leg wedge
C
, and mount leg brace
F
as shown in Figure
1. The hinge pin positioning is an important assembly element. The pin
must be oriented as in Figure 1
for the unit to fold correctly. The hinge
mounts to the inside face on the open side of the wedge
. Use (2) 5 x 15mm
Hex head bolts and (2) 5mm Nylon lock nuts.
3. Insert inner leg wedge
C
into outer leg
D E
. Open side of the wedge
should face the same direction as the open side of the outer leg.
4. Place the roller frame
A B
upside down on a level surface and mount
the leg clips
G
. The clips mount in the top holes of the center crossmem
-
bers as the frame is currently oriented (see Figure 2
). This will put
them on the bottom of the frame when the unit is in the upright position.
Use (2) 5 x 15mm Hex head bolts and (2) 5mm Nylon lock nuts.
5. Attach loose leaf leg hinge
K
to inner leg wedge
C
. Orient so when
the leg is in an upright position (as the leg would be during use) the
unsecured 1/2 of the hinge hangs down. Flat side of hinge should be
toward the wedge. Pin side of the hinge facing out, or away from wedge
.
Secure with (4) 5 x 15mm Hex head bolts and (4) 5mm Nylon lock nuts.
Feed the bolts through the hinge first.
6. Fold the leg brace in half and lay the leg assembly onto the roller frame
.
Orient so the unsecured 1/2 of the hinge hangs down and inline with the
holes in the roller frame cross-member. Secure the hinge to the roller frame
with (4) 5 x 15mm Hex head bolts and (4) 5mm Nylon lock nuts.
Figure 3 and
Figure 4.
7. Tip the unit onto its side and swing the legs into thei
r vertical position.
Attach the unsecured ends of the leg braces to the ce
nter cross-member
of the roller frame. DO NO
T ATTEMPT T
O ATT
ACH THESE WITH THE
FRAME UPSIDE DOWN! The leg could slam into the closed position
causing an injury. Secure with (2) 5 x 15mm Hex head bolts and (2) 5mm
Nylon lock nuts. Figure 2
.
8. Install the (4) adjustable glides
L
into the threaded bosses of the legs.
9. T
urn the assembled unit upright and install the rollers using the flat blade
of a putty knife like a shoehorn. The spring axles will snap into place
.
Figure 2
Figure 1
Figure 3
Figure 4
Содержание HGP-10
Страница 8: ...8 Notes...
