T2000-T2100
EN – 19
5.5.3. Deleting the internal memory
1. Press the
ON/OFF
key (>2s) to switch off the instrument
2. Press both the
ON/OFF
key and the
MEM
key at the same time
3. The “Clr” message is shown on the display for a few seconds (see Fig. 32), the
instrument deletes all saved data and automatically switches on in measuring mode
Fig. 32
5.6.
SETTING OF ALARM THRESHOLDS IN RESISTANCE MEASUREMENT
1. Press the
ON/OFF
key to switch on the instrument
2. Press and hold (>2s) the
AL
key in order to enter the alarm threshold setting section.
The screen below is shown:
Fig. 33: Setting of alarm thresholds in resistance measurement
3. Shortly press the
A
key (T2000),
RS232
key (T2100) or
key to respectively
increase or decrease the limit value of the alarm threshold in the range:
1
÷
199
4. Shortly press the
AL
key to confirm the alarm threshold value set and go back to
measuring mode
