HSU 500A, Инструкция по эксплуатации

Страница: 6 / 16

1
Chapter 1: Setting Up
In this chapter, we will unpack and setup your new amplifier!
Features
The 500-Watt Amplifier features built in high pass and low pass crossovers, a phase switch, high
and low level inputs and a dual voltage switch. These features will be discussed throughout the manual.
The amplifier is designed to power up to two of our TN series subwoofers in parallel.
Unpacking
Carefully open the box and remove the amplifier. Included in the box you will find this manual, a
power cord, and a ground cheater plug (three prongs to two prongs). Use the cheater plug if you are
experiencing humming or buzzing noise due to ground loops problems. When using the cheater plug,
bend back the grounding tab away from the side that plugs in to the wall so that you do not ground it, as
this would ground the amplifier and defeat the purpose of using the cheater plug.
Amplifier Placement
Our preference is to place the Hsu amplifier close to your main amplifier and/or
receiver/processor. This allows you to use short interconnects. Make sure you have adequate ventilation
around the amplifier. If you are running two subwoofers in parallel, some forced cooling may be
advisable. A couple of AC 3-inch whisper fans from Radio Shack (wire them in series this makes them
run very quietly) on top of each heat sink blowing up works well.
Chapter
1