August-2015
Page 12
4.
Installation
Before working with panel mounting, wrist strap must be used to discharge any static
charges to the ground from human body to protect board electronic sensitive elements. Input
power terminals and battery terminals must be completely disconnected.
As shown from panel case drawing, it contains 3 holes for mounting. Panel contains
sufficient place to mount the case without removing the main board. If this is not possible for
some cases, main board can be removed. First remove all connected cables at the upper side
of the main board. Remove power socket at the right down side of the board. Remove the left
side cable which connects the main board to the display board by opening the lock parts of the
socket and unplug the cable. Then remove the 6 screws which mount the main board to the
case. There is one at each side of the board and one at the top middle and one at the bottom
center.
Mark and drill the holes and attach screw elements and tighten it. Clean drilling place
from any dust then install the main board and fix it with the 6 screws. Install all removed
cables.
At the top side of the case, there are 16 X 20mm holes used for insertion of different
cables to the panel. Remove only black plastic parts which close the needed holes.
