HSB Beta 100-D-ASS, Оригинальное руководство по сборке и обслуживанию, Страница: 16 / 31

Installation and adjustment
14
2020-07-22 FM 239 MuW Beta Type Z Rev.01
6 Installation and adjustment
The carriage drive of the linear unit can be attached by way of the
tapped and through holes on the top and sides of the bearing casing.

Install the linear unit on a flat surface. Unit parallelism < 0.2 mm/
1,000 mm.
6.1 Attaching the load on the linear unit base profile
Attachment options The load can be attached on the base profile by the following methods
(Figure 3):
•
By way of the tapped holes on both front faces
•
By way of tapped hole rails
•
By way of sliding blocks
•
By way of the T-slot on the underside
Sliding blocks
Figure 3: Sliding blocks (1) in the groove on the underside of the base profile
Procedure 1.
Align the linear unit.
2.
Align the sliding blocks (1).
3.
Tighten the load (for tightening torques see section 3).