HS LN42, Руководство по эксплуатации

Страница: 13 / 13

O p e r a t i o n M a n u a l o f M i n i D o m e C a m e r a
Chapter Four Trouble Shooting
Problems Possible Causes Solutions
After power on, no motion and
no image. Power supply damage or low
power
Replace
Wrong power cable wiring Correct
Engineering wiring fault Detect
Abnormal self detect, normal
image with motor sound
Mechanical fault Repair
Tilted camera Reposition in the right way
Lower power supply Replace with appropriate power
supply and optimally place the power
supply near the dome device
Normal self detect, but no image
Wrong video wiring Correct
Bad contact of video cable Detect
Camera damage Replace
Self detect success, but out of
control
Wrong wiring of control signal
cable Correct
Unmatched dome device address Select again
Unmatched protocol Adjust protocol to match the control
system and power on again
Unstable image Bad contact of video cable Detect
Low power supply Replace
Dome device out of control Abnormal self detect Power on again
Bad contact of control cable Detect
Wrong with main device
operation Power on the main device again
Overload or too long
communication distance
1
．
Confirm terminal impedance
2
．
Raise the distributor
Vague image Focusing is not at the best
position
Open the dome and readjust
13