Issue F: 18/02/14
10
INSTALLATION OF THE FIRE-BED INTO
THE STOVE
IMPORTANT NOTE!!
CERAMIC COALS AND LOGS GET VERY HOT! NEVER ATTEMPT TO
HANDLE HOT COALS OR LOGS WITH BARE HANDS AND NEVER PLACE
HOT COALS OR LOGS ON OR NEAR COMBUSTIBLE SURFACES.
NO RESPONSIBILITY FOR ANY INJURY HOWEVER CAUSED
WHILST HANDLING HOT COALS, LOGS OR CERAMICS CAN BE
ACCEPTED BY HS GAS.
FIRE-BED ARRANGEMENT
This appliance can be fitted with either ‘coal effect’ or ‘log effect’ ceramics.
If you are fitting ‘Coal Effect’ ceramics please follow the instructions set out in
‘Section A – Fitting the Coal Effect Ceramic Matrices’ (Page 10).
If you are fitting ‘Log Effect’ ceramics please skip ‘Section A’ and follow the
instructions set out in ‘Section B – Fitting the Log Effect Ceramic Matrices’ (Page
13).
Section A -
Fitting the ‘Coal Effect’ Ceramic Matrices
N
ATURAL
G
AS
:
The fire-bed is constructed of 3 ceramic matrices, 4 small
coals, 10 medium coals and 4 large ‘diamond shaped’ coals.
LPG:
The fire-bed is constructed of 3 ceramic matrices, 10 small coals, 4
medium coals and 4 large ‘diamond shaped’ coals.
1.
Place the rear ceramic matrix into
the fire. The ceramic should sit on the
burner tray top and be placed so that it
touches the back of the firebox (As
shown in diagram A9).
2.
Place the middle ceramic matrix into the fire
so that the flat surface sits on the burner tray.
Push the middle ceramic back until it rests
against the rear ceramic shown in diagram
A10.
Note!
Make sure that the middle ceramic does not
block any of the burner tray slots.
Diagram A9
Diagram A10
