V i s i t
h t t p s : / / h q t e l e c o m . c o m
f o r l a t e s t d o c u m e n t a t i o n & s u p p o r t
P a g e
12
16.2
Trigger EMERGENCY sequence calls
In On-hook status, press the “SOS” button on the wireless pedant for 3 seconds to start the dialing out of stored emergency
number(s) automatically.
To order additional pedants, please visit our online store at
https://hqtelecom.com
17
Replacing the built-in batteries on the Wireless Pedants (or remote controllers)
17.1
Replacing the built-in batteries on the Wristband pedant
This pedant is equipped with two (2) 3V lithium batteries (CR2016 coin-cell). To replace them, open the unit using a Phillip
head screw driver (TIP: make sure you use one that fits the screws to prevent wearing them out). Once opened, use a flat
head screw driver (or something similar) to carefully push the 2 batteries out the metal enclosure (Tip: please be careful not to
push too hard to avoid breaking the contacts on the sides of the metal enclosure.
NOTE: There is a resistor with a loose end inside the enclosure – don’t worry, that’s normal). After replacing the batteries,
test it to make sure it works (no need to pre-program it). After testing it, put it back and close the unit, then tie the screws
again. Done!
17.2
Replacing the built-in batteries on the Necklace pedant.
This pedant is equipped with one (1) 12V/27A battery (MN27 Alkaline battery). To replace it, open the unit using your hand
or a thin plastic tool (e.g. plastic fork or flat-head screw driver) TIP: You may need to apply heavy force in order to separate the
2 parts. Once opened, pull the battery out and replace with a new one. Then put back together applying gentle pressure.
Then, test it to make sure it’s operational. Done!
To order additional pedants or batteries please visit our online store at
https://hqtelecom.com
