VDPLOW2403_v2
HQPOWER™
3
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used… Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5 m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5. Remote Control Description
1.
BLACK OUT button: set the light output on or off.
2.
A button: set the unit to the automatic pre-programmed effects.
3.
PROG button: select one of the 7 pre-programmed colour effects by
pressing the + or - button.
4.
F button: flash button, set the flash on or off. Flashing can be
increased or decreased with the + and – buttons.
5.
SP button: set the running speed. The button is available only in
colour jumping or colour fading, increasing or decreasing with the +
and – buttons.
6.
D button: set the unit in DMX mode.
7.
SA button: set the unit in sound mode (this option is unavailable for
outdoor lighting).
8.
SL button: set the unit in slave mode.
9.
number buttons: set the DMX address.
6. DMX
Address Setting
Set the DMX address of your
VDPLOW2403
using the included remote control.
Examples:
Address Setting: 245
1.
Press the S button; the red LEDs are on: you can start to set the address.
2.
Press numeric button #2; the green LEDs are on: 2 (hundreds) setting successful.
3.
Press numeric button #4; the blue LEDs are on: 4 (tens) setting successful.
4.
Press numeric button #5; all the LEDs are on: complete setting successful.
