VDP575MHS20FL_v2
HQPOWER
9
f.
Projector Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to “listen” to the DMX controller. Enter the correct
number and read it from the display located on the base of the
VDP575MHS20FL
.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the
VDP575MHS20FL
s will “listen” to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set different addresses, each device will “listen” to a separate channel number. Changing the settings of one channel
will only affect the device in question.
In the case of the 20-channel
VDP575MHS20FL
, you will have to set the start address of the first
VDP575MHS20FL
to 1, the second
VDP575MHS20FL
to 21 (1 + 20), the third to 41 (21 + 20) and so on.
g.
Control Panel
Access the main menu by pressing the wheel. Browse through the menu by turning the wheel. Press the
wheel to enter a submenu.
RSLTN: 8-bit or 16-bit movement resolution
Tilt rev: reverse vertical movement
Pan rev: reverse horizontal movement
DMX addr: DMX address between 1 and 492
Exit: exit the selected option
Reset: reset the device
Lamp: lamp on / off control
h.
Main Functions
•
DMX512 Address Settings:
Enter DMX addr and select the desired address code using the wheel. Press
the wheel to confirm and exit the menu.
•
Pan Reverse:
Enter Pan rev to invert the pan movement. Select YES or NO. Press the wheel to confirm
and exit the menu.
•
Tilt Reverse:
Enter Tilt rev to invert the tilt movement. Select YES or NO. Press the wheel to confirm and
exit the menu.
•
Movement Resolution:
Enter RSLTN to select the 8-bit or 16-bit movement resolution using the wheel.
Press the wheel to confirm and exit the menu. The 16-bit movement resolution will occupy 16 DMX
channels; the 8-bit movement resolution will occupy 14 DMX channels. Refer to the DMX protocol
section in this manual.
•
Lamp on / off:
Lamp control via the menu.
•
Reset Function:
Enter Reset and press the wheel to reset all the settings to the standard settings.
i.
Remotely Controllable Functions
•
Lamp:
The lamp can be switched on and off via a DMX controller without affecting the rest of the lighting.
Note that the lamp is not a hot-restrike type. Please wait for approximately 10 minutes after having
switched off the device before turning it back on.
•
Colour Wheels:
The AERON 575S is equipped with two 10-position colour wheels – 9 of these are with
dichroic colours and the last one is open. The primary colour can be positioned between 2 adjacent
Содержание VDP575MHS20FL
Страница 2: ...VDP575MHS20FL_v2 HQPOWER 2 ...
