VDLPW1600
HQPOWER
4
Chase 2 s***f_**, Chase 1 s***f_**, Chase 1 s***f_**, DMX mode 8-group/4-group/2-group/1-group, DMX mode
3channel/6channel.
The above sequence is looping when rolling the wheel in an anticlockwise direction. Press the jog wheel to enter the
setting.
NOTE:
Whenever idle for 3 seconds, the LCD will display “Addr
***
” when there is a DMX signal,
***
indicating the
present DMX address. When there is no DMX signal, the projector will preset a non DMX running mode: auto,
sound or manual. The LCD returns to the last menu option when operating the wheel again.
•
Addressing
The DMX address is defined as the first channel from which the
VDPLW1600
will respond to the controller. Press the
wheel and rotate to change the address. After setting the desired address, confirm by pressing the wheel again.
•
Light Brightness Adjustment
The LED brightness is manually adjustable. Press the wheel and rotate to display following setting options:
Manual blue***
(adjustment of the blue LEDs)
Manual green***
(adjustment of the green LEDs)
Manual red***
(adjustment of the red LEDs)
The adjustment value ranges from 0 ~ 255 – the higher the value, the brighter the LEDs will be. To enter these
settings, press the wheel.
•
Non DMX Running Modes
Disconnect the device from the DMX signal first. Press the jog wheel and scroll to
No DMX Auto/Sound/Manual
.
Press the wheel again to enter. Select your mode (
Auto
: auto running mode –
Sound
: sound activation –
Manual
:
manual mode), press to confirm.
Chase
A chase is a sequence of different steps in a continuous loop. The
VDPLW1600
allows you to select up to 8
different chases with adjustable speed and fade time.
Example: To set the fade time of chase 8, press the wheel and rotate to select
Chase 8 s *** f_**
. Pay attention to
the position of the cursor. Scroll the wheel to switch the cursor between speed (
s ***
) and fade time (
f **
). When
the cursor is flashing after the letter “
f
”, press the wheel and adjust the fade time of chase 8. Press again to
confirm. When the cursor is flashing after the letter “
s
” (
Chase 8 s_*** f **
), press the wheel and adjust the speed
of chase 8. Press again to confirm. Repeat this operation to program chases 1 ~ 7.
DMX Mode Group
The LEDs of your
VDPLW1600
are evenly divided into 8 square blocks, which can be grouped. To set a group,
press the jog wheel and scroll to
DMX Mode 3channel/6channel
. Press the wheel again to enter. Rotate the wheel
to the right to select the 6-channel mode; rotate to the left to select the 3-channel mode.
