Installation
Installing a wall switch adjacent to the power source is recommended.
1. Remove the mounting bracket from the back of the fitting (figure A & B).
2. Loosen the cord anchorage on the mounting bracket by loosening the two screws (figure C).
3. Choose rubber-sheathed 3-core circular cord, H05RN-F 3G 1mm
2
(not supplied) for the mains wiring.
4. Insert mains wiring through the grommet on the mounting bracket (figure D).
5. Connect the mains wiring to the terminal block as marked on the mounting bracket. Ensure that the wires are secure and no bare wires are
exposed (figure E).
6. Use the mounting bracket as a template to mark the screw positions onto the wall (figure F).
7. Install the mounting bracket onto the wall. Ensure the method of fixing can support up to a 10kg weight.
8. Place the mains wiring in the cord anchorage system and secure by tightening the screws. Ensure it clamps onto the cord sheath (figure G).
9. Install the fitting back onto the mounting bracket and tighten the screws (figure H&I).
10. Adjust the head and sensor of the fitting to the desired position.
11. DO NOT MEGGER TEST.
A
C
D
E
F
G
H
I
B
A
C
D
E
F
G
H
I
B
A
C
D
E
F
G
H
I
B
A
C
D
E
F
G
H
I
B
A
C
D
E
F
G
H
I
B
