19
Figure 19 Connecting the console cable
Setting terminal parameters
To access the device through the console port, you must run a terminal emulator program
(HyperTerminal, PuTTY, or Tera Term) on the configuration terminal. For information about using a
terminal emulator program, see the program's user guide.
The following are the required terminal settings:
•
Baud
rate
—9600.
•
Data
bits
—8.
•
Stop
bits
—1.
•
Parity
—none.
•
Flow
control
—none.
Connecting an AC power cord
1.
Make sure the router is reliably grounded, and the power switch on the router is in the OFF
position.
2.
Connect one end of the AC power cord to the AC receptacle on the router, and the other end to
the AC power source.
3.
Install the bail latch and push it leftward to secure the power cord.
