MF877-00 Page 2
Template Revision A
HPE instructions for this template are available at
Item Description
Notes
Quantity
of items
included
in product
Components, parts and materials containing
radioactive substances
0
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Tool Size (if
applicable)
Phillips screwdriver
M3, M2.5
Flat-blade screwdriver
Small adjustable wrench
Needle nose pliers
socket wrench
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective
treatment:
1.
Remove the chassis lid
1.
Using a Phillips screwdriver, remove the screws (qty 25)
2.
Slide the lid off the chassis
3.
Slide the QSFP lid off the chassis bottom.
2.
Remove the two power supplies
1.
Locate the power supplies on the right side as you are facing the back of the chassis
2.
While pressing the release lever toward the handle, pull the power supply out of the chassis
3.
Repeat for the other power supply
3.
Remove the six Fan Module
1.
Locate the Fan Module on the right side as you are facing the back of the chassis
2.
Using a Phillips screwdriver to remove the screw, pull the Fan Module out of the chassis.
3.
Repeat for the other Fan Module
4.
Remove the CPU PCA
1.
Using a Phillips screwdriver, remove the screw on the CPU PCA
2.
Slide the CUP PCA toward the back of the chassis then lift the right side to remove it
5.
Remove the main PCA
1.
Disconnect the fan cable from the main PCA
2.
Using a Phillips screwdriver, remove the 12 screws holding down the main PCA
3.
Using a socket wrench, remove the 4 spacer holding down the main PCA
4.
Using a Phillips screwdriver, remove the 2 screws on air baffles
5.
Remove the 2 air baffles.
6.
Slide the main PCA toward the back of the chassis then lift the rear side to remove it
7.
Using a Phillips screwdriver, loosen the four screws holding down the CPU heat sink
8.
Remove the 2 heat sinks and brackets
6.
Remove the FAN PCA
1.
Using a Phillips screwdriver, remove the screw on the FAN PCA
2.
Lift the FAN PCA to remove it
