HPC Tiger SHARK, Руководство пользователя

Страница: 41 / 65

5.4
Machine Adjustments
The Tiger SHARK
™
is calibrated and tested prior to shipment. Adjustments should not be required to cut keys to
any of the DSDs.
However, over time, re-sharpened cutter wheels and other factors may cause the machine to cut out of calibra-
tion. In this instance, you can electronically adjust the calibration of the machine.
Prior to making any machine adjustments, it is imperative to verify the machine is out of calibration. To check the
calibration of the machine, cut several different types of keys and use a micrometer to carefully measure the
depths and spaces. Compare these measurements with the lock manufacturer's specifications.
Tiger SHARK™ Auto-Calibration
Fig. 1
Fig. 2
AutoCal
Card
Update
CARD
Calibration Disk
No. CMB-CKDISC
AutoCal Card
No. SHARK-32
Calibration Key
No. SHARK-21
The Auto-Calibration process requires the standard
operating program to be replaced with the Auto-
Calibration program. Some features of the machine
will not be available while using the Auto Calibration
program.
3/32” Allen Wrench
No. WRENCH-4
Items needed for auto-calibration:
1. Using the 3/32” Allen Wrench, remove the plate
covering the Update Card Receptacle. Next, remove
the Update Card by gently pushing down on the card
to release it, then sliding the card up and out of
receptacle (Fig. 1) .
2. Insert the Auto-Calibrate Card into receptacle. Make
sure it is properly inserted and seated in the receptacle.
The contacts on the card face outward (toward the rear
of the machine), and the card must “click” into place.
(Fig. 2)
.
Note: On older machines the card does not “lock” into
place. Just slide the card in and out. The contacts face
the front of the machine.
CALIBRATE
Tools
Fig. 3