HPC MLFPK Series, Инструкция по установке и эксплуатации

Страница: 6 / 11

6
4/24/2017 870-MLFPK
6. Installation of Fire Pit

IMPORTANT: To prevent damage, unhook fire pit from gas supply for pressure leak tests.

IMPORTANT: Burn Testing- It is the responsibility of the qualified installer to test for gas leaks at all
connections.

IMPORTANT: Gas Plumbing Connections: Use only joint compound or tape that is resistant to all gases. Apply
joint compound to all male pipe fittings only- DO NOT use on flex line flared fittings . Be sure to tighten every
joint securely.

Refer to cut sheets on our website for important dimensional information for your fire pit- visit www.hpcfire.com

Perform all leak tests with leak detector or leak reactant.
Installation Steps:
1. Shut off Gas Supply to fire-pit.
2. Connect fire-pit to main gas supply. Flex lines- avoid sharp bends with flex line to prevent whistling.
3. Turn on gas supply, purge gas lines of air and perform leak test on all inlet connections. Repair as needed.
4. Position fire pit safely with access to all gas connections for testing.
5. Light fire pit. It may take several cycles to purge air from the lines.
6. Once fire pit is lit perform leak test on all gas connections. Repair as needed.
7. Turn off fire pit and allow cooling.
8. Apply media as described in (Section 7). When filling the pan with lava rock and/or decorative glass, the instructions
in Section 5 must be followed.
9. Turn on fire pit again and perform leak test with media correctly installed. If gas leak is detected verify correct media
application and repair as needed.
10. Set fire pit in properly constructed enclosure (Section 6).
11. Verify correct operation and lighting.
12. Review safety manual with end user and instruct not to change/ modify fire pit or media.
13. Leave manual with end user.
14. Please apply the Start Up and Shutdown decal next to control box in an obvious position.
7. Media Application
WARNING: FOR GLASS MEDIA USAGE WITH LP GAS- WHEN USING APPROVED DECORATIVE GLASS TO
COVER BURNER APPLY ONLY ENOUGH TO HIDE BURNER. APPLYING OVER 1/2” MAY CREATE BACK
PRESSURE AND GAS LEAKAGE FROM AIR MIXER RESULTING IN LP POOLING UNDER FIRE PIT.
WARNING: FOR GLASS MEDIA USAGE WITH LP GAS- THE UNIT MUST BE TESTED WITH MEDIA OVER
BURNER FOR CONFIRMATION OF NO BACK PRESSURE CREATING GAS TO LEAK OUT OF AIR MIXER
VENTURI HOLES. THIS MAY HAVE TO BE DONE PRIOR TO PLACING IN ENCLOSURE IF NO ACCESS DOOR.

IMPORTANT: The fire pit is designed to use approved media correctly installed over the burner to achieve proper combustion.

Never install a mesh or screen under the media.

Media affects flame pattern greatly. It is possible to create an unusual flame pattern that could damage your
enclosure. Enclosure damage from an open flame fire feature is not covered under any warranty.

The use of concrete logs is not recommended.
Installation
We suggest that our products be installed by professionals
that are locally licensed by the authority having
jurisdiction in gas piping.