HPC MLFPK Series, Инструкция по установке и эксплуатации

Страница: 4 / 11

4
4/24/2017 870-MLFPK

HPC cannot guarantee the lip on all of our products will be perfectly flat and will not warp due to heat.

Product must be accessible for service.
5. Construction of the Remote LP Tank System Enclosure
IMPORTANT:
Only select models of Push Button / Flame Sense (FPPK) fire pits are permissible for small tank use-
please see HPC Product catalog, visit www.hpcfire.com or contact your HPC Dealer for details.
For an enclosure using an LP tank system, follow these recommended specifications:

You must follow local codes.

IMPORTANT: The remote LP Tank / Enclosure should be a minimum of 54” from the burner.

One side of the enclosure shall be completely open; OR

For an enclosure having four sides, a top, and a bottom:
o
At least two ventilation openings shall be provided in the side walls of the enclosure, located within 5 in
(127mm) of the top of the enclosure, equally sized, spaced at a minimum of 180 degrees, and
unobstructed. The opening(s) shall have a total free area of not less than 1in
2
lb (14.2 cm
2
kg).
See Figure 1.
o
Ventilation opening(s) shall be provided at floor level of the enclosure and shall have a total free area of
not less than ½ in
2
/lb (7.1cm
2
/kg) of stored fuel capacity. If ventilation openings at floor level are in a
side wall, there shall be at least two openings. The bottom of the openings shall be 1 in (25.4mm) or less
from the floor level and the upper edge no more than 5 in (127mm) above the floor level. The openings
shall be equally sized, spaced at a minimum of 180 degrees and unobstructed. See Figure 1.

Every opening shall have minimum dimensions so as to permit the entrance of a 1/8 in (3.2mm) diameter rod.

Ventilation openings in sidewalls shall not communicate directly with other enclosures of the appliance.
Figure 1