5.2.3 Cutting Too Far From The Shoulder
Note: only recalibrate the shoulder gauge after being sure that the tip gauge is properly
calibrated.
) Select a shoulder gauged, factory cut type key, such as a Schlage or Arrow. Check to
see that the # space (closest to the shoulder) is greater in depth than a # cut.
2) Install the correct cutter wheel.
) Turn the CodeMax
®
on.
4) Select and enter the proper DSD number.
5) Enter in a # cut for the depth. Then press ENTER to accept, and press START to
begin the cutting process.
6) The Pivot Arm will start to travel laterally towards the key. When the Pivot Arm travels
to the first cut (closest to the shoulder) and the key begins traveling towards the cutter
(making the depth cut), push the Emergency Stop Button.
7) Loosen the key in the jaw. Slide the key to your right until the pin seat of the cut is
directly opposite the flat of the cutter. Tighten the key in the jaw.
8) Release the Emergency Stop Button to allow the machine to return to the Home
position.
55
CodeMax
®
CodeMax
®
