
8
PM6200
1. SPEAKER OUTPUT JACKS
The PM6200 contains a two-channel power amp. The
two channels can be used independently to supply
200W+200W, or bridged to provide 400W output power.
NOTE:
Use the front panel MODE switch to select which
signal is sent to the speaker output jacks, and to activate
BRIDGE mode
If the two power ampli
fi
ers are used for MAINS operation,
two 8 ohm speakers can be “daisy-chained’ together and
connected to the AMP 1 jack, and two more 8 ohm speak-
ers can “daisy-chained” together and connected to the
AMP2 jack, for a total of four speakers.See the diagram
on page 9.
The total impedance load for each ampli
fi
er must not be
less than 4 Ohms, therefore in the example above, two
speakers with an impedance of 8 ohms each are con-
nected to each amp’s output jacks.
If you wish to use two ampli
fi
ers independently, let’s say
for Main and Monitor operation, use a 4 through 8 ohm
speaker. Again the total impedance load for each ampli
fi
er
must not be less than 4 ohm. Therefore two speakers with
impedance of 8 ohms can be “daisy-chained” together and
then connected each amp’s output jacks.
If the two ampli
fi
ers are use in a BRIDGE more, only one
speaker can be connected to the BRIDGE jack. The total
impedance load while operating in Bridge mode must not
be less than 8 Ohms.
Rear Panel Controls
Rear Panel Controls
AMP 1
MAIN BRIDGE
AMP 2
ON
OFF
POWERED MIXER 200W X 2
PM6200
POWER
DESIGNED AND ENGINEERED IN KOREA
WARNING
DO NOT EXPOSE THIS
EQUIPMENT TO RAIN
OR MOISTURE
CAUTION
FOR CONTINUED
PROTECTION AGAINST
RISK OF FIRE, REPLACE
ONLY SAME TYPE FUSE
AVIS
RISQUE DE CHOC
ELECTRONIQUE NE PAS
OUVRIR
ATTENTION
UTILISER UN FUSIBLE
DE RECHANGE MEME
TYPE
If you are connecting a speaker to the BRIDGE jack, use
an 8 through 16 Ohm speaker.
CAUTION: When using a bridge connection, do not con-
nect anything to the AMP1 and AMP2 jacks. Likewise,
when using the POWER AMP1 and POWER AMP2 jacks,
do not connect anything to the BRIDGE jack.
2. POWER SWITCH
This switch is used to turn the unit on and off. When the
unit is on, the front panel Power Indicator LED is lit.
WARNING
W
ELECTRONIQUE NE PAS
2
1
Содержание PM 6200
Страница 2: ...WARNING...
Страница 16: ...14 PM6200 Block diagrams Block Diagrams...
Страница 19: ...17 PM6200...
Страница 20: ......