4.
Remove the TouchPad (4) by sliding it away from the top cover at an angle.
Reverse this procedure to install the TouchPad.
USB/VGA connector board
Description
Spare part number
USB/VGA connector board (includes cable)
784455-001
Before removing the USB/VGA connector board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the service cover (see
Service cover on page 51
), and then remove the following components:
a.
Battery (see
Battery on page 53
)
b.
Keyboard (see
Keyboard on page 63
)
c.
Base enclosure (see
Base enclosure on page 75
)
Remove the USB/VGA connector board:
1.
Release the ZIF connector (1) to which the USB/VGA connector board cable is connected, and then
disconnect the USB/VGA connector board cable from the system board.
2.
Remove the two Phillips PM2.0×8.0 screws (2) that secure the USB/VGA connector board to
the top cover.
ENWW
Component replacement procedures
83
Содержание ZBook 14 G2 Mobile Workstation
